Repeater settings

Repeater region configuration

MeshCore Region Configuration Guide for Lincolnshire

Updated 17 October 2026

This guide explains how to configure MeshCore regions for repeaters participating in the Lincolnshire MeshCore Network.

Regions help organise MeshCore traffic geographically, allowing repeaters to participate in regional networks while reducing unnecessary message propagation.

1. Connect to Your Repeater

Connect to your MeshCore repeater using a compatible CLI interface.

2. Configure Your Regions

Enter the following commands one at a time, pressing Enter after each command and ensure you get an ok response returned in the CLI

region put lincolnshire
region default lincolnshire
region put yorkshire
region put eng-ne
region put northwest
region save

What Each Command Does

Command	Description
region put lincolnshire	Adds the Lincolnshire region
region default lincolnshire	sets lincolnshire as the default
region put yorkshire	Adds the Yorkshire region
region put eng-ne	Adds the North East England region
region put northwest	Adds the North West England region
region save	Saves the region configuration

3. Verify Your Configuration

Once the regions have been saved, you can check your configuration using:

region list allowed

Check that the expected regions appear in the allowed list.

4. Additional Information

Region names should be entered exactly as shown.
Use lowercase letters for consistency.
Run region save after making changes.
Only configure regions appropriate to your repeater and its intended network participation.
Adding regions alone does not automatically block unscoped traffic or other regions.